Grinding, Sanding Accessories (Page 6 of 6)
These are the parts that mount the wheel, catch the dust, and quiet the exhaust on CP air grinders and sanders. Wheel guards are listed in 3 in., 4 in., and 7 in., with flange kits sized for 4-1/2 in. (115 mm) and 5 in. (125 mm) discs plus the disc nuts, wheel collars, and adapters that go with them. Die grinders take collets from 2.4 mm and 2.5 mm through 3 mm, 6 mm, and 1/4 in. — the 3 mm collet for the CP9104 is the routine reorder. Dust comes off through angle sander shrouds, extraction kits, and bag sets, while clippable silencers and exhaust hose cut noise and blow-back. Fit them to air grinders and sanders & polishers, then feed them abrasives.
Showing 121–122 of 122 resultsSorted by popularity
Showing 121–122 of 122 resultsSorted by popularity
Guards, Flanges, and Collets
Three fits to confirm. The guard has to match the wheel: 3 in., 4 in., and 7 in. guards are listed, including a complete 7 in. and a 7 in. US kit. The flange kit has to match the disc, and the C kit covers 4-1/2 in. (115 mm) and 5 in. (125 mm). The collet has to match the burr shank, 2.4 mm to 6 mm and 1/4 in.
Dust Extraction and Shrouds
Shrouds and extraction kits pull dust off at the tool instead of into the shop air, and a clean face leaves a cleaner finish. CP lists shrouds by disc size and attachment style, with kits for cut-off and orbital sanding and bag sets. See also vacuum & dust extraction accessories.
| Model | Size | Type |
|---|---|---|
| CPA5001 | 2 in. | Angle sander shroud, TR |
| CPA5003 | 2 in. | Right angle shroud, TS |
| CPA5004 | 3 in. | Right angle shroud, TS |
| Dust extract kit KA16 | 180 mm | Grinder dust kit |
| Dust ext kit CP3650 | — | Cut-off tool kit |
Match the shroud to the disc size and to the TR or TS attachment on your holder.
Silencers, Exhaust Hose, and Handles
Exhaust hose, listed in a 0.75 m length and as complete kits, routes spent air away from the work on a corrugated wall that damps noise without choking the tool. Clippable silencers, including the Typhoon, cut the discharge crack at the port. Vibration-damping side and dead handles steady the second hand.
Common Questions
Which collet fits a CP9104Q die grinder? CP lists 2.4 mm and 3 mm collets for the CP9104. Measure the shank of the burr you run and order the collet to that shank, not to the tool.
Do you sell grinding chucks and collet holders? Yes — collet holders, holder kits, collet nuts, spindles, and a rear flange auto balancer. See the tools they fit on the CP air grinder page.
What size guard do I need? Match the guard to the wheel you run, not the tool’s maximum. Guards cover 3 in. through 7 in.; a guard sized over the wheel leaves the disc edge exposed.