Chicago Pneumatic Cutting Accessories
Cutting accessories are what an air cut-off tool or reciprocating saw actually cuts with, and the pack you reach for depends on the material. Chicago Pneumatic 101 mm reciprocating blades come five to a set in 18T, 24T and 32T tooth counts — coarse for fast rough cuts, fine for thin sheet and tube. Abrasive cutting discs ship in five-piece sets for hard materials, and the 180 mm diamond cutter blade handles abrasive work that eats bonded wheels. They run on CP air cutting tools; for grinding wheels and flap discs see abrasives.
Showing all 6 resultsSorted by popularity
Price range: $34.00 through $36.00 Select options This product has multiple variants. The options may be chosen on the product page
Price range: $20.00 through $41.00 Select options This product has multiple variants. The options may be chosen on the product page
Showing all 6 resultsSorted by popularity
Tooth Count Sets the Cut
On a reciprocating saw the blade decides everything. An 18-tooth blade clears chips fast and suits thicker stock where a rough edge is acceptable. 24T is the general-purpose middle. 32T puts more teeth in contact, which is what thin sheet, tube and conduit need — too coarse a blade there catches and strips teeth. The single CP reciprocating blade covers the same back-and-forth rough cutting.
Bonded Discs vs. Diamond
Bonded abrasive discs cut by wearing away, so they are cheap, fast, and consumed. The 180 mm diamond blade costs more up front and lasts far longer in hard, abrasive material. CP catalogs its cutting and grinding discs at 2 to 3 in. for the small-tool line, with the larger diamond blade for heavier cut-off work.
Blade and Disc Comparison
| Item | Type | Size & teeth | Pack |
|---|---|---|---|
| Saw blade 101 mm 18T | Reciprocating | 101 mm, 18 teeth | 5 pcs |
| Saw blade 101 mm 24T | Reciprocating | 101 mm, 24 teeth | 5 pcs |
| Saw blade 101 mm 32T | Reciprocating | 101 mm, 32 teeth | 5 pcs |
| Reciprocating saw blade | Reciprocating | See product page | Single |
| Diamond cutter blade | Diamond | 180 mm | Single |
| Cutting disc set | Bonded abrasive | See product page | 5 pcs |
Check arbor and shank against your tool before ordering; the range above is the current CP cutting line.
Common Questions
Which tooth count should I buy? Match teeth to wall thickness. Keep at least three teeth in the cut — 18T for solid and thick stock, 24T general purpose, 32T for sheet, tube and conduit. Buying the five-packs in two counts covers most shop work.
What tool do these blades fit? They are cut for CP air saws and cut-off tools, listed under cutting tools. CP’s pneumatic cutting line runs 0.35 to 0.5 hp on 5.5 to 17 CFM through a 1/4 in. inlet, so a small compressor drives one.
Do you stock grinding discs too? Yes — wheels, flap discs and backing pads sit under grinding and sanding accessories, with the wider range on the accessories index.