The Rhino GPD-45 Multi-Pro TS is a 42 lb gas powered tent stake driver built for commercial tent, event, military and emergency-response crews. The tent stake chuck and top throttle come factory-installed, so stakes drive straight from the case no compressor, generator or rotating sledgehammer crew with the Honda GX35 4-stroke hitting 1,720 blows per minute and the top-handle trigger finishing each stake from ground level instead of overhead.
The stake chuck sits on the same 2-1/2 in. I.D. Chuck-Lok master chuck as the standard Multi-Pro GPD-45, so the full adapter family ground rod through 2-3/8 in. round post swaps on without tools. Most event crews pair it with the tent stake and ground rod puller for teardown, and the wider Rhino gas post driver lineup covers everything from T-posts to wood posts.
- Honda GX35 4-stroke, 35.8cc OHC single-cylinder engine runs on straight unleaded gasoline with no fuel-oil mix
- 1,720 BPM blow rate keeps event setup crews moving through high stake counts
- Tent stake chuck factory-installed on the 2-1/2 in. I.D. Chuck-Lok master chuck
- Top throttle pre-installed at the factory start with the side throttle, finish driving from the top
- 42 lb fueled; 14 x 11 x 24 in. tool dimensions; 0.67 gal fuel capacity
- Cast aluminum body manufactured in Kewanee, Illinois; CIS Compression Isolation System and padded grips reduce hand-arm vibration
- Honda 2-year residential / 1-year commercial engine warranty plus Rhino Lifetime Impact Warranty
- Stocked by Crowder Supply in Denver with free UPS Ground shipping
Tent Stake Driver FAQ
Why a dedicated tent stake driver instead of sledgehammers?
One operator and 1,720 blows per minute replace a rotating sledge crew stakes go in faster, straighter, and with far less back strain on big-top, event, military and emergency-response setups.
Can it drive posts and ground rods too?
Yes. The tent stake chuck sits on the same 2-1/2 in. I.D. Chuck-Lok master chuck as the Multi-Pro GPD-45, so the full adapter family ground rod through 2-3/8 in. round post swaps on without tools.
How do you pull the stakes back out?
Teardown goes as fast as setup with the Rhino tent stake and ground rod puller the companion tool most event crews order with the TS.
What warranty does the Multi-Pro TS carry?
The Honda GX35 engine carries Honda’s 2-year residential / 1-year commercial warranty, and the driver itself is covered by the Rhino Lifetime Impact Warranty. The cast aluminum body is manufactured in Kewanee, Illinois.
