This striking bar fits Tamrock RD314 drifters and carries an R32 thread for the drill string. The RD314 is one of the Tamrock and Sandvik models covered by Crowder Supplys striking bar and shank adapter program, and this R32 configuration is quoted to your drills specification rather than sold off the shelf, so length and lead time are confirmed with your order.

R32 rope thread puts this bar in one of the most common handheld and drifter systems: run matching extension rods out to an R32 carbide button bit and every joint in the string shares one thread. RD212 owners will find that drills 1 in. NC striking bar listed separately, and the adapters buyers guide covers thread identification.

• Direct-fit striking bar for Tamrock (Sandvik) RD314 rock drills
• R32 rope thread connection to the drill string
• Quote-only configuration, built and confirmed to your RD314s specification
• Transfers piston impact from the drifter into rods and bit
• Part of a shank adapter program covering 13 drill brands and 18 thread options
• Stocked and supported by Crowder Supply in Denver

RD314 R32 Striking Bar FAQ

Which drills does this striking bar fit?
It is made for Tamrock (Sandvik) RD314 drifters and carries an R32 rope thread on the drill-string end, so it connects to standard R32 rods and bits.

Why is this striking bar quote-only?
Striking bars are built and confirmed to your drill’s exact specification rather than sold off the shelf, so we verify the configuration, length and lead time with your order before quoting.

My drill is an RD212, not an RD314 — is there a bar for it?
Yes, the RD212 uses a separate 1 in. NC striking bar listed on its own page, and our shank adapter program covers 13 drill brands and 18 thread options if you run something else.