Texas Pneumatic Rivet Busters

Texas Pneumatic rivet busters are the U.S.-built TX133 series — a three-stroke matrix sized for road and bridge repair, structural-steel demolition, and rivet cutting. The best-selling long-reach TX13311 (11 in.) and standard TX1338 (8 in.) lead the line, with the short-stroke TX1336 (6 in.) for tighter access. Each comes in inside- or outside-trigger form. All run off an air compressor. Free Shipping.

Showing all 5 resultsSorted by popularity

Showing all 5 resultsSorted by popularity

Texas Pneumatic TX133 Range

Built by Texas Pneumatic Tools in the U.S., the TX133 matrix matches stroke to section: the TX1336 (6 in.) for tight, overhead work, the most-commonly specified TX1338 (8 in.) for standard bridge-deck and tank-wall sections, and the long-reach TX13311 (11 in.) for cutting rivet shanks up to 15/16 in. and reaching thick sections. Closed-grip inside-trigger models suit general demolition; the outside-trigger (-OT) variants move the trigger to a finger sleeve for under-bridge and awkward-angle work.

Applications & Accessories

Pound for pound there is no harder-hitting hammer — even a paving breaker would need twice the weight for an equal blow, yet low blow frequency and a teasing throttle keep it controllable. Crews use them on bridge-deck repair, structural-steel and rivet/bolt cutting, tank and boiler work, and reinforced-concrete demolition. Match a cutter or point from rivet buster chisels, size your air compressor to the tool, and compare every brand across all rivet busters. Free Shipping.