The paving breaker ground rod driver lets a paving breaker sink grounding rods in seconds instead of long minutes of sledging: a socketed head seats over the rod, keeps it vertical and lands every blow on center. Rod sizes run 1/2 in. through 1 in., on hex shanks from 7/8 x 3-1/4 in. to 1-1/4 x 6 in. to match your breaker’s chuck.
Grounding work spans electrical services, substations, power transmission and telecom, and a driven rod is only as good as its alignment the socket prevents the wandering and mushrooming that hand driving invites. For lighter rods with a chipping hammer, there is a chipping hammer version; our other driving tools for paving breakers handle pins and spikes, and the paving breaker buyer’s guide matches chuck size to breaker class.
- Rod sizes: 1/2, 5/8, 3/4, 7/8 and 1 in. grounding rods
- Hex shank options: 7/8 x 3-1/4, 7/8 x 4-1/4, 1 x 4-1/4, 1-1/8 x 6 and 1-1/4 x 6 in.
- Socketed head keeps the rod vertical and every blow centered
- Heat-treated steel for repeated impact driving without deforming
- Applications: electrical grounding, substations, power transmission, telecom installations
- Stocked by Crowder Supply in Denver across the full shank and rod size matrix
Ground Rod Driver FAQ
How do I order the right size?
Match two dimensions: the hex shank to your breaker’s chuck (7/8 x 3-1/4, 7/8 x 4-1/4, 1 x 4-1/4, 1-1/8 x 6 or 1-1/4 x 6 in.) and the socket to your rod diameter (1/2, 5/8, 3/4, 7/8 or 1 in.).
Will it fit my paving breaker?
Yes, as long as your breaker runs a standard 7/8, 1, 1-1/8 or 1-1/4 in. hex chuck — pick the shank option that matches and the driver drops in like any other steel.
Is there a gas-powered way to drive ground rods?
If you don’t have a compressor and breaker on site, a gas-powered post driver fitted with a ground rod drive kit is the usual alternative — see our Rhino gas post drivers.
